Philips SatinPerfect Epilierer - Manual (Page 13)

Problem Cause Solution
The epilator does
not work.
The socket to which
the appliance is
connected does not
work.
Make sure the socket is live. If you connect the
epilator to a socket in a bathroom cabinet, you may
need to switch on the light in the bathroom to make
sure the socket is live. You could also use a working
socket outside the bathroom.
The overheat
protection has been
activated.
When the epilator stops working and the speed
setting indications start flashing red, the overheat
protection has been activated. Let the appliance cool
down. The lights stop flashing after 30 seconds. When
the appliance has cooled down, switch on the epilator
again. If the lights start flashing again, the epilator has
not yet cooled down sufficiently.
The overload
protection is
activated because
something got
caught between the
rotating discs or
because you pressed
the appliance too
hard onto your skin.
When the overload protection has been activated, the
speed setting indications flash red. Turn the discs with
your thumb until you can easily remove the item that
is blocking the rotating discs. Then switch on the
appliance again. Do not press the appliance too hard
onto your skin.
EnglisH 13
4203.000.4504.1.indd 13 10-12-09 11:48