Brew group – Philips Saeco Syntia Kaffeevollautomat User Manual

Page 39

Advertising
background image

• 39 •

English

• It is recommended to clean the water

tank daily.

- Remove the small white fi lter in the

water tank and wash it under running
drinking water.

- Reposition the small white fi lter in

its housing by gently pressing and
turning it at the same time.

- Fill the water tank with fresh drinking

water.

• Empty and clean the drip tray daily.

Perform this operation also when the
fl oat is raised.

• Wash the brew group with lukewarm

water and carefully clean the upper
fi lter.

• Thoroughly wash and dry all the parts

of the brew group.

• Thoroughly clean the inside of the

machine.

• Make sure that the brew group is in

rest position. The two references must
match.

• The lever on the rear part of the brew

group must be in contact with the base.
Press the “PUSH” button to make sure
that the brew group is in the correct
position.

Lubricate the brew group af-
ter approximately 500 brew-

ing cycles. The brew group lubricant
may be purchased at authorized
service centers.

• Lubricate the brew group guides using

the supplied lubricant only.

• Apply the lubricant evenly on both side

guides.

• Insert the brew group in its seat until it

locks into place WITHOUT pressing the
“PUSH” button.

• Insert the dregdrawer. Close the service

door.

Brew Group

• The brew group must be cleaned at

least once a week.

• Turn off the machine by pressing the

ON/OFF button and remove the plug
from the socket.

• Remove the dregdrawer. Open the

service door.

• To remove the brew group, pull it by the

handle and press the «PUSH» button.
The brew group must be washed only
with lukewarm water, no detergent/
soap is necessary.

• Also clean the seat of the tray every

week through the openings on the
bottom of the machine.

Advertising
This manual is related to the following products: