Bissell ProHeat 2X 9500-P - Manual (Page 2)

1. Slide upper handle onto machine base
2. Screw 3 screws into the marked holes
3. Place upper hose rack onto back of upper handle, and secure with screw
4. Place lower hose rack onto back of upper handle by pushing in and sliding
down until it snaps firmly into place
5. Wrap power cord and flex hose
6. Keep flex hose snugly in place by using the hose secure latch
7. Attach tool to hose grip (extra tool storage on back)
1. Move furniture to another area if cleaning an entire room
2. Remove large dirt and debris from carpet (See User's Guide for more details)
3. Pre-treat spots & stains and heavy traffic areas (optional – see User's Guide)
4. Fill the clean water tank
4a. Unlatch the top by lifting up on tank latch
4b. Remove the top
4c. Fill the bladder with clean hot tap water
4d. Re-attach top by hooking the lip of the tank top into the groove of the
tank bottom and secure the latch
5. Fill the formula tank with water and BISSELL 2X formula
5a. Remove formula tank and unscrew the cap and insert
5b. Fill with water to the WATER line
5c. Fill with BISSELL 2X formula to the FORMULA line
5d. Replace cap and insert and place back into formula tank holder
6. Set Custom Clean Dial (located on the upper handle)
7. Set ReadyTools Dial ("FLOOR CLEAnInG” for carpet cleaning or “TOOLS”
for cleaning with the hose and tool)
8. Plug into outlet, and turn the power and heater (if desired) switch on
9. If using the heater, let the machine warm up for 1 minute before cleaning
Your assembly is now complete.
a. Tough Stain Brush
4a.
4d.
6.
4b.
5a.
7.
4c.
5b.
8.
1.
4.
2.
6. 7.
3.
For complete user's guide, visit www.bissell.com
Assembly Before you begin cleaning
a
Power Heater