BT FREELANCE XA 2000 - Manual (Page 13)

BT Freelance XA 2000 UG ~ 2nd Edition ~ 8th October ’04 ~ 6393
11
Before you use your BT Freelance XA
2000 for the first time, it is important
to have the handset batteries fully
charged. The batteries need to charge
continuously for at least 16 hours
to reach full charge.
Place the handset on the base.
The red charging light will come on.
The handset comes pre-registered to
the base station as HANDSET HS1.
This is shown on the display. The
icon and the battery icon are shown
on the display. Once the handset is
fully charged, the display shows a full
battery symbol.
3 Charge the handset batteries
for at least 16 hours
2 Install the rechargeable
batteries in the handset
Battery low warning
If the handset battery symbol is empty
and flashing, and you hear a warning
beep every 10 seconds, you will need
to recharge your handset before you
can use it.
The handset uses two rechargeable
Nickel Metal Hydride (Ni-MH) AAA
batteries which are supplied. Take
care to insert the batteries as shown
and then fit the battery cover (the
battery cover may be found in the
packaging with the batteries).
SETTING
UP
Please note that the red charging light
will remain on even when the batteries
are fully charged.
BATTERY LEVELS
WEAKHALF-FULL FULL
Note
The symbol on your handset display
indicates when you are in range of
the base station. If the symbol flashes
and you hear a warning beep, you
are out of range and will need to move
closer to the base station.