Pq-6 plus (ro) – Black Box PS035A User Manual

Page 21

Advertising
background image

PQ-6 PLUS (RO)

20

DEVICE ADDRESS 0
DEVICE ADDRESS 7
DEVICE ADDRESS 6
DEVICE ADDRESS 5
DEVICE ADDRESS 4
DEVICE ADDRESS 3
DEVICE ADDRESS 2
DEVICE ADDRESS 1
DEVICE ADDRESS 0

Printer=5224

Printer=5225

Page Eject is Form Feeds

Page Eject is Line Feeds

Command Pass Thru is Disabled

Command Pass Thru is Enabled

Current printer attached is Generic 3400h
Current printer attached is IBM Proprinter
Current printer attached is Okidata 2410
Current printer attached is Okidata 83/84
Current printer attached is MX-80
Current printer attached is T.I. 810/820
Current printer attached is NEC SpWr 3500
Current printer attached is FX-80

Press FF to save configuration
Press STOP to cancel configuration

S

ELECTING

S

WITCH

S

ETTINGS

This mode lets you change the initial switch settings using the front panel instead of removing the top cover of
the PQ-6 PLUS.

Follow the instructions on the printed menu to select the different switch selections.

Upon exiting this mode, the switch selections will be stored in nonvolatile memory; the PQ-6 will retain

them until you change them using the front panel. On the next power-up, the PQ-6 PLUS will be configured to
the last stored setup. If no previous configuration was stored, the PQ-6 PLUS will default to the current switch
settings on the PC board, and the printer type will be Generic 3400h.

Advertising
This manual is related to the following products: