Bissell 6489 - Manual (Page 5)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
1. Connect hose to vacuum by inserting
hose connector on the end of the hose
into the suction inlet. Make sure the hose
is positioned so the tabs on the hose
connector line up with the notches on
the suction inlet. Once inserted into
the suction inlet, turn clockwise to lock
into place.
2. Attach extension wands section together
by inserting into one another and
twisting slightly to tighten.
3. Connect hose handle to the end of
the extention wand and twist slightly
to tighten.
4.
Connect floor nozzle to the end of
the extension wand and twist slightly
to tighten.
5.
Once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor nozzle)
into the storage slot on the rear of
the vacuum.
WARNING:
Plastic film can be dangerous. To
avoid danger of suffocation, keep
away from babies and children.
1.
4.
3.
2.
5.
5
Suction Inlet