B&K CT600.1 - Manual (Page 14)

B K
&
S B
IMPLY ETTER!
8
Accessories Guide
B&K CT Series MZ-128 Remote Controller Reference Sheet
The MZ-128 Remote Controller has multiple useful functions:
1.The MZ-128 Remote Controller may be used to control and setup a CT Receiver.
2. The MZ-128 may be used as a source of IR for use in programming learning key-
pads, etc.
3. The MZ-128 may be set to source the B&K IR functions listed below, for code sets
000-128 and 999.
Setup the MZ-128 to use a discrete B&K code set:
1. Install 4 AAA batteries into the remote. Observe polarity.
2. Press and hold the B&K and MUTE buttons simultaneously for two seconds. The
LED will light up solid red and stay illuminated.
3. Firmly press the desired B&K three digit code set. Always use three digits
(i.e. 0-1-1 Zone A)
4. Press the B&K button again to confirm setup. The red LED will blink three times
when the IR code has been successfully programmed.
(MZ-128 Default Factory Code-Set is: 0-0-0 Whole House Control)
Code-Set 128 Simply Explained
Code-set 128 is a special code-set which allows
individual control of the Hardware Zone that the
IR data is received by. It will not function when
received by the unit’s front panel i.e. Two key-
pads are plugged into Zone A&B’s Control I/O
ports, when the remote comes into IR view of the
keypad in Zone A, the 128 Code-Set remote will
only control Zone A, when in Zone A. Take that
same remote into Zone B and it will only control
Zone B. MZ-128 BUTTON B&K IR FUNCTION
[B&K ALL COMMANDS]
ON/B&K/POWER ALL B&K POWER UP
OFF ALL B&K POWER OFF
VOLUME ALL B&K VOLUME UP
VOLUME ALL B&K VOLUME DOWN
0 ALL B&K VOLUME 0DB
2 ALL B&K VOLUME -20DB
4 ALL B&K VOLUME -40DB
6 ALL B&K VOLUME -60DB
MUTE ALL B&K MUTE TOGGLE
CODE SET 000-128
CODE SET 999
MZ-128 BUTTON B&K IR FUNCTION
[TUNER]
AM SELECT THE AM BAND
FM SELECT THE FM BAND
TUNE + TUNE FREQUENCY UP
TUNE - TUNE FREQUENCY DOWN
STA + TUNER FAV PRESET UP
STA- TUNER FAV PRESET
M STEREO / MONO
[NAVIGATION]
MENU MENU UP/DOWN LEVEL
LEFT LEFT OR BALANCE [L]
RIGHT RIGHT OR BALANCE [R]
SEL/ENTER SELECT OR ENTER
UP UP
DOWN DOWN
SAVE SAVE
EXIT TOTAL EXIT FROM ALL
ZONE ZONE SELECT
[NUMERIC]
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
+10 +10
MZ-128 BUTTON B&K IR FUNCTION
[POWER STATE]
B&K POWER ON
POWER POWER TOGGLE
OFF POWER OFF
[VOLUME]
MUTE MUTE TOGGLE
VOLUME MASTER VOL UP
VOLUME MASTER VOL DOWN
[TONE CONTROL]
B+ BASS UP
B- BASS DOWN
T+ TREBLE UP
T- TREBLE DOWN
LOUD LOUDNESS TOGGLE
[INPUT SOURCE]
S+ SOURCE UP
S- SOURCE DOWN
V+ VIDEO SOURCE UP
D-IN ZONE DEDICATED INPUT
AM AM TUNER
FM FM TUNER
IN1 IN 1 OR [V1]
IN2 IN 2 OR [V2]
IN3 IN 3 OR [TV]
IN4 IN 4 OR [DVD]
IN5 IN 5 OR [CD]
IN6 IN 6 OR [SAT]
IN7 IN 7 OR [TAPE]
IN8 IN 8 OR [V4]
IN9 IN 9 OR [V5]
[FAVORITE PRESET]
PRESET FAVORITE PRESET UP
PRESET FAVORITE PRESET DOWN