Bissell 8940 - Manual (Page 7)

7
Plug the PowerSteamer into a proper outlet and turn ON
the Power Switch.
Make one slow forward and backward wet pass by
pushing the SprayTrigger. Caution: Do not overwet.
Release the Spray Trigger and make one slow forward
and back pass over the same area to remove any resid-
ual dirty water.
Repeat cleaning passes without pressing the Spray Trigger
until you can’t see any more water being suctioned up.
When cleaning job is complete, refer to
Maintenance/Storage.
Turn Power Switch OFF.
Unplug Power Cord from outlet and coil cord around
Power Cord Quick Release.
Remove Tank-in-Tank. Dispose of dirty water.
Rinse out Tank-in-Tank and re-seat the tank
onto the machine.
Wipe all exterior surfaces with a soft cloth.
Store cleaner in a protected, dry area.
When carpet is dry, vacuum again to remove hair and
fuzz that the PowerSteamer may have loosened.
NOTE: Turn off machine and unplug from wall outlet.
Step on Handle Release pedal and recline Handle on
floor (see illustration).
Remove the Tank-in-Tank. Set aside (see illustration).
Maintenance/Storage
Normal Cleaning
1.
2.
1.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
Pump Belt Replacement
To Remove Broken Pump Belt
2.
CAUTION:
PowerSteamer uses water
and must not be stored
where there is a danger of
freezing. Freezing will
damage internal components
and void the warranty.
OFF ON
Power Cord
Quick Release
2 1