Belkin N Wireless Router PM01122 User Manual
Page 26
24
N Wireless Router
sections
table of contents
1
2
3
4
6
7
8
9
10
5
alTeRNaTe seTUP MeTHod
(2)
(1)
setting your Connection Type
From the “Connection Type” page, you can select the type of connection
you use. Select the type of connection you use by clicking the button (1)
next to your connection type and then clicking “Next” (2).
setting your Internet service Provider (IsP)
Connection Type to dynamic IP
A dynamic connection type is the most common connection type found
with cable modems. Setting the connection type to “dynamic” in many
cases is enough to complete the connection to your ISP. Some dynamic
connection types may require a host name. You can enter your host
name in the space provided if you were assigned one. Your host name is
assigned by your ISP. Some dynamic connections may require that you
clone the MAC address of the PC that was originally connected to the
modem.
1� Host Name (1)
This space is provided to enter a host name that needs to be visible to
your ISP. Enter your host name here and click “Apply Changes” (3). If your
ISP did not assign you a host name, or you are not sure, leave this blank.
2� Change WaN MaC address (2)
If your ISP requires a specific MAC address to connect to the service,
you can enter a specific MAC address or clone the current computer’s
MAC address through this link.
(2)
(1)
(3)