Bushnell 13-7507 - Manual (Page 7)


HOW TO CHANGE THE BATTERIES
To change the battery, use a coin to remove the battery compartment cover by turning it counter-
clockwise, until the “unlocked” icon and white dot on the cover line up with the dot on the
binocular. Set the cover aside and remove the battery. Note the “+” and “-“ polarity markings on
the battery. Be sure to insert the new battery correctly, in the same direction as shown on the
sticker inside the battery compartment, with the “+” (positive) terminal going in first so it is at the
bottom of the compartment, and the “-“ negative end facing the battery cover. Replace the battery
cover with the “unlocked” icon and two dots lined up again, then turn it (with fingers or a coin)
until the “locked” icon lines up with the dot on the binocular. The battery should be taken out if the
binoculars will not be used for a long time. Batteries left in the binocular for prolonged periods of
time without being used may leak and cause damage to the binocular. After replacing the battery,
be sure to follow the calibration procedure for the digital compass.
Battery Requirement: One CR2 Lithium (3 volt)
Cover
Unlocked
Cover
Locked
Polarity
Sticker
Digital Compass Marine Bino 13757 7 6/10/08 9:04:02 PM