Bushnell 118213 - Manual (Page 4)


CAMERA OPERATION INSTRUCTIONS
Button Descriptions
The MODE button has three functions:
1. Power on: Press and hold the button until the
camera turns on. When the camera is connected
to a PC via the USB cable provided, the camera
will power on automatically.
2. Power off: While the camera is on, press and
hold the button until the camera turns off. If
the camera has not been used or if a button has
not been pressed for over 2 minutes, the camera
will automatically power off to save battery life.
If the camera is connected via USB, it will not
power off except when the PC power is off.
3. Mode change: press the button rapidly to change modes.
B. The SNAP button has two functions:
1. Take a picture: press this button to take a picture when the camera is
on. (But not in the PC mode or mode change.)
2. Select: in “Mode Change” press this button to confirm the function.
Mode Snap
118213 QVC Imageview-1LIM.indd 4 8/17/06 10:19:03 PM