AMICA Built-in refrigerators BK309.3FA EN - Manual (Page 15)

15
1) A++/A+ (=low consumption) to G (=high consumption).
2) The energy consumption refers to the yearly consumption in kWh, indicated according to DIN EN 153.
Deviations may occur in the practical operation of the appliance, depending on the use and place of its
location.
3) *= storage room of approximately. -6°C
(**) = storage room of approximately. -12°C
(***) = freezing storage room of approximately -18°C
(*/***) = freezing storage room of approximately -18°C or below
4) Climate range means that your set temperature is maintained at ”normal” ambient temperature. Should the
room temperture drop significantly below the defined scope, the appliance does not work so often and the
undesirable temperature increase may occure.
SPECIFICATION EN
2
3
4 5
CHANGING THE DIRECTION OF THE DOOR OPENING
1. Before reversing the door opening direction, unplug the appliance and remove all food.
2. Using a flat screwdriver pry and remove hinge caps.
3. Using a Phillips screwdriver remove the door upper hinge while holding the door (Fig. 2).
4. Using a Phillips screwdriver remove the middle hinge while holding the upper door
5. Set the door aside in a safe place.
6. Tilt the appliance (up to 40 degrees) so as to have sufficient access to the lower hinge (Fig. 3).
7. Using a Phillips screwdriver remove lower door hinge
8. Attach the lower hinge on the other side (Fig. 4).
9. Position the door assembly in such a way so that pin of the lower hinge is aligned with the appro-
priate hole of the lower door bracket.
10. Attach the middle hinge on the other side of the appliance so that the lower pin of the middle hinge
is aligned with the appropriate hole of the upper door bracket. Position the second door assembly so
that the upper pin of the middle hinge is aligned with the appropriate hole of the lower door bracket.*
11. Attach the upper hinge so that the hinge pin is aligned with the appropriate hole of the upper door
bracket.* (Fig. 5).
12. Check that doors are properly aligned with the appliance body.
13. Replace the hinge caps.
14. Switch on the appliance as described in the relevant section of its operating instructions.