BenQ HDR-16EP - Manual (Page 6)

6
III. INSTALLATION
3-1 Hard Disk Installation
1. Insert the Removable Hard Disk to the rack, and make sure it is well mounted.
Lock the hard disk drive with its key.
3-2 Connect to Monitor
1. Place the monitor that you purchased.
2. Connect the VGA cable (with D-type, High Density, 15 pins plug) to the VGA
port on the back of the HDR-16EP.
3. Plug in the power cord of the monitor.
3-3 Connect to Camera
1. Mount and adjust the cameras. This manual does not instruct you how to
install, set up, or adjust the camera. Please refer to other books/manuals or ask
your camera supplier.
2. Connect the camera to the HDR-16EP with a 5C2V coaxial cable. Video input
connectors for HDR-16EP are BNC female type. If cable with F connector to
be used, a “BNC to Female” connector is needed.
3. HDR-16EP uses 4 capture cards. CH1-CH4, CH5-CH8, CH9-CH12,
CH13-CH16 is on the same card.
4. Please don’t mix plug color cameras and B/W cameras on the same board to
keep the best video quality.
3-4 Other Connections
1. Connect the power cord to the power socket on the back panel.
2. Connect the PS/2 mouse to the PS/2 mouse socket.
3. The operation of HDR-16EP doesn’t need the keyboard.