Bissell POWERSTEAMER PROHEAT PLUS 16981 - Manual (Page 16)

16
Dirtlifter ® PowerBrush ® does not turn.
Possible Causes Remedies
The Brush Belt or Pump Belt Turn the machine OFF and unplug from the
may be broken. outlet. To check if a Brush Belt has broken,
you will need a flat head screwdriver.
Insert the blade end into the lower slot of the
Belt Access door to release the lower snap. If
necessary, insert the blade end into the upper
slot to release the upper snap. Examine for
belt breakage. The Brush Belt should be
visible, looped around the motor shaft.
If it is broken or missing, please refer to
Part Numbers and Descriptions on
page 17 before calling Consumer Services.
Complete installation instructions will
accompany the replacement belt.
Vacuum not picking up solution.
Possible Causes Remedies
ReadyTools ™ switch may be at the Set ReadyTools ™ switch to either Tools or
wrong setting for the cleaning job. PreTreat or Floor Cleaning.
Drain cap may be missing or not Remove Tank-in-Tank, ™ loosen and
properly installed at back of re-tighten Drain Cap.
Tank-in-Tank. ™
Tank-in-Tank ™ lid is not Re-install lid; refer to The Basics section.
properly installed.
Tank-in-Tank
™ is not properly seated. Tank-in-Tank ™ must be firmly seated to
function; remove and reseat Tank-in-Tank. ™
Poor tool position. Adjust angle; apply more downward pressure.
(Hand held attachments only).
Tank-in-Tank
™ has picked up Empty Tank-in-Tank, ™ refer to
maximum dirty water. The Basics section.
Troubleshooting - continued