Baby Trend Sit N Stand Plus 7581 - Manual (Page 5)

WARNING:
Avoid serious injury from
falling or sliding out. Always use the seat belt.
TO SECURE FRONT/REAR SITTING CHILDREN
1 The shoulder straps of the 5-point harness has 2 attachment positions.
Select the loop position that places the shoulder strap level with, or below
the top of the child’s shoulder and feed the shoulder harness under the
correct loop. Please see figure 10.
2. Carefully place the child in the stroller seat and bring the safety harness
around the child’s waist and over the shoulders. Place the crotch strap
and between the child’s legs. Insert the male end of each shoulder / waist
belt into the buckle on the crotch strap. Tighten the harness to be snug
around the child’s waist and over the child’s shoulders. Please see figure
11.
3. To release, apply pressure to both sides of each male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child. NOTE: Buckles may be hard
to release when 1st used.
1. The rear platform and jump seat are designed to accommodate a child
who is at least 2 1/2 years old, has good balance and coordination, and is
not over 40 inches tall. Position the child on the platform on the back of
the stroller. Be sure child is facing forward and hands are holding frame.
Secure the safety belt behind child and engage buckle. See figure 12.
2. Be sure that the child’s feet are fully on the platform at all times.
PLEASE NOTE: When using the rear SEAT you must put the STAND
FEATURE SAFETY BELT in the storage location located on the rear of
the seat. Please See Fig. 12A
WARNING:
To avoid a possible
choking hazzard when using the rear seat, put
the STAND FEATURE SAFETY BELT in the
storage location on the rear of the seat.
I
TO SECURE REAR STANDING CHILD
TO SECURE CHILD
Fig. 11.
Fig. 12.
Shoulder Strap
Squeeze
Crotch Strap
Waist
Strap
Adjust for a
snug fit
Fig. 10.
5
1. Have child sit on the jump seat facing backwards. Secure the seat belt,
which is attached to the back of the seat, around the child’s waist, and
buckle to the crotch strap. See figure 12B. Adjust the seat belt to be snug
around the child’s waist.
2. To release, apply pressure to both sides of the male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child.
3. Be sure that the child’s feet are fully on the platform at all times.
TO USE JUMP SEAT
Fig. 12A.
Fig. 12B.