Philips AJ130B-37B - Manual (Page 10)

Autostore
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be
erased.
1 Press and hold PROGRAM/SET TIME until
the frequency in the display starts running.
➜ Available stations are programmed (FM).
After all stations are stored, the first auto-
store preset station will then automatically
play.
To listen to a preset or autostore
station
Press the PRE 3, 4 buttons once or more
until the desired preset station is displayed.
CD playback
• This CD clock radio can play only audio discs
including CD-R (CD-recordable), CD-RW
(CD-rewritable), and MP3.
• Do not try to play a CD-ROM, CDI,VCD,
DVD or computer CD.
1 Press POWER to switch on from standby.
➜ The system will switch to the last selected
source.
2 If CD is not selected, press SOURCE once
or more to select it.
➜
is displayed.
3 Lift the CD door to open.
4 Insert a CD with printed side facing up, and
close the CD door.
➜ ---- is displayed briefly, then total CD track
number.
5 Press ); to start playback.
6 To view CD track information, press
DISPLAY.
➜ The current track number is displayed for
several seconds (See 3), then it will
switch back to clock display.
7 To adjust the sound, turn VOLUME 3, 4.
8 To interrupt, press );.To resume playback,
press ); again.
9 To stop playback, press 9.
Selecting a different track
• Press ∞ /§ once or repeatedly until the
desired track number appears on the display.
• In the stop position, press ); to start playback.
➜ The selected track number appears briefly
on the display when you press ∞ /§ to
skip tracks, then it switches back to clock
display.
Finding a passage within a track
1 During playback, press and hold down ∞ /§.
➜ The CD is played at high speed and low
volume.
2 Release ∞ /§ when you recognize the pas-
sage you want.
➜ Normal CD playback resumes.
Programming tracks
You may store up to 20 tracks in the desired
sequence for playback. If you like, store any
track more than once.
1 In the stop position, press PROGRAM/SET
TIME to enter programming mode.
➜ PROG and P01 are displayed, flashing,
indicating the start of programming
(See
4).
2 Press ∞ /§ to select desired track.
3 Press PROGRAM/SET TIME to store the
track.
➜P02 is displayed, flashing, indicating the
second program sequence is available.
3 Repeat steps 2 to 3 to select and store all
desired tracks.
➜ If you attempt to store more than 20
tracks, no tracks can be stored.
4 Press ); to play the program.
➜ PROG is displayed.
To review a program,
In the stop position, press and hold
PROGRAM/SET TIME until all the stored
tracks are displayed.
CD Player
AVIS
AVISO