Philips 50PF7220A-37 - Manual (Page 36)

34
HDMI HDMI
1 2
CABLE / ANTENNA
75
HDMI
HDMI
DVI
DIGITAL
AUDIO
IN
R L
MONITOR OUT
VIDEO IR OUT
DIGITAL
AUDIO
OUT
HDMI HDMI
1 2
CABLE / ANTENNA
75
L Pr H
R Pb V
Y
Pr
Pb
Y
S-VIDEO
S-VIDEO
AV2
AV3
AV1
VIDEO
L
R
VIDEO
DIGITAL
AUDIO
IN
DIGITAL
AUDIO
OUT
R L
MONITOR OUT
VIDEO IR OUT
DIGITAL
AUDIO
OUT
Connect a Digital MultiChannel Surround receiver to the DIGITAL AUDIO OUT
connector at the bottom of the TV.
HDMI is the leading new standard for Digital video and audio
interconnection.To the
HDMI connector you can connect HDMI devices
such as a Set Top Box or compatible DVD-R or DVD player with HDMI, or
DVI-equipped devices like a computer.
So you can display high-definition pictures on this TV in the digital form.
Note: If the accessory device has DVI output only, use a DVI to HDMI adapter
cable to connect to the
HDMI connector. (Then also connect the audio cable to
DIGITAL AUDIO IN .)
& Connect your HDMI device with one of the HDMI connectors.
é Select the connected digital device in the Setup, Source menu, p. 16.
The HDMI IN connectors allow the following TV and monitor display
modes:
HD Standard Definition TV (SDTV) 640/720 x 480i
Enhanced Definition TV (EDTV) 640/720 x 480p
High Definition TV (HDTV) 1920x1080i
1280x720p
PC VGA 640x480 60 Hz
SVGA 800x600 60 Hz
XGA 1280x768 60 Hz
Notes:
- If necessary, you can adjust the picture position to the center of the screen with
the cursor keys.
- Due to legal requirements, it is possible that with certain copy protected PCM
audio qualities from a device connected to the HDMI input, the DIGITAL
AUDIO OUTPUT signal is muted.
- Your TV supports HDCP (High-bandwidth Digital Content Protection). This is a
system for protecting DVD content outputted via DVI from being copied. It
provides a secure digital link between a video source (DVD, PC, etc.) and your TV.
Content is encrypted at the source device to prevent unauthorized copies from
being made.
- Proper working is only guaranteed with HDMI compliant consumer products.
- Digital devices from different manufacturers have the possibility of differing
output standards which may cause difficulties for the television to properly
display.
- In case no signal is detected from your HDMI device, turn off the HDMI device
and then on again.
To get an optimal viewing, it is advised to turn your DVD player to one of the
following TV display standards: 1920x1080i, 1280x720p, 720x480i or
720x480p.
Digital Surround receiver
HDMI (High Definition Multimedia Interface) connectors