Philips 3000 series LED-LCD TV 32PFL3509 32" class-po - Manual (Page 16)

7
Press OK to finish Settings assistant.
Exit Back Store
You have set up your viewing preferences.
Settings assistant
●
When the initial setup is completed, the lowest memorized
channel with the confirmation message of the location setting will
be displayed on the TV screen.
●
You must set Home in step 4. Otherwise, Picture and Sound
settings you adjusted will not be memorized after the unit goes
into Standby mode.
Note(s)
●
If you are not receiving a signal from your Cable service, contact the Cable provider.
● If you press B or Q during Autoprogram, this Setup of TV channels will be Cancelled.
●
The Initial Autoprogram function can be executed for either Antenna or Cable only Once.
When you change the Connection (Antenna / Cable), select Autoprogram again.
L p. 24
● If there is no signal Input from the Antenna terminal and no operation for several seconds
after you Turn On the Unit, Helpful hints appears. Follow the instructions listed on the
TV screen.
Skip OK Select
Later
Retry
Initial setup
the appropriate source input.
press "SOURCE" key on the remote control to select
the input which you have connected to the box and
If you are using a cable or satellite box, please confirm
installation process searches this connection.
ANTENNA IN jack on the back of the TV, the channel
Verify that you have a cable connected to the
Try Autoprogram again?
No channel is registered.
After an Initial Setup is completed...
●
If you want to scan the channels Automatically again.
Autoprogram L p. 24
●
You can add the desired Cable and Analog channels not memorized by
Autoprogram.
Add channels L p. 25
●
If you want to change to another Language.
Language L p. 31
●
If you want to change the Location setting.
Location L p. 31
●
If you want to restore the picture setting.
Settings assistant L p. 22
16 .
English