Philips AJ260-37 User Manual

Clock radio

Advertising
background image

AJ260

Clock Radio

QUICK START
MISE EN SERVICE RAPIDE
INICIO RÁPIDO

Thanks for buying Philips AJ260 clock radio.
Our Quick Start guides you through just some of the features on the set.
Please read our instruction booklet to really rise & shine!

Press ALM1 or ALM2.

Radio

1. Press RADIO ON/OFF once to switch on the

radio.

2. Press AUTO SCAN/DATE to program all

available stations.

3. Press PRESET+/- until the desired preset station

is displayed.

Weather forecast and Indoor
thermometer

The unit can auto detect and measure atmospheric
pressure changes to graphically display the weather
forecast in the next 12 to 24 hours, and current
indoor temperature.

Note:

The weather forecast based on the atmospheric

pressure may vary slightly from the actual weather
situation.

Using the outdoor sensor

The outdoor sensor is supplied to work with the
main unit to measure and display the outdoor
temperature.
1. Place the sensor in a desired open area. The place

must be within 50 meters away from the main
unit. (Make sure that the sensor is loaded with 2

AA batteries.)

• For the first time using the outdoor sensor

and the main unit, press

RESET located on the

sensor back, and

RESET located in the battery

compartment of the main unit. Then, the main
unit will begin to receive transmission from the
sensor.

To update the outdoor temperature from the

sensor any time, press and hold

ENGLISH

Step A

Connect the supplied mains adapter to the set’s

7.5V DC jack and the plug into a wall outlet.

Step B
How to set the Clock & Alarm time

1. Press and hold TIME SET / RCC SYNC or

ALM1 / ALM2 until the time digits flash.

2. Press and hold TUNING +/- to adjust time.
3. Press TIME SET / RCC SYNC or ALM1 /

ALM2 to confirm.

4. Repeat the steps 2~3 to complete all the other

time items setting.

To perform RCC (Radio Controlled Clock)
searching

Press briefly

TIME SET / RCC SYNC. is

displayed.

Notes:

The RCC time search will stop 10 minutes later if no

time signal is received.

Refer to the supplied user manual for RCC

information.

Step C
Selecting the Alarm mode

In standby mode, slide the

RADIO/BUZ to select

desired mode.

Helpful hints:

If you have selected

RADIO, make sure you have

properly tuned to a station before turning off the set.

3

ways to switch off the alarm

Either press briefly: SLEEP/ALARM RESET or

REPEAT ALARM/BRIGHTNESS CONTROL.

C

A

B/3

3

R

B

DC 7.5V

R

AJ260_37-QSG_sheet

6/3/07, 18:51

1

Advertising
This manual is related to the following products: