Black & Decker BLP6600M - Manual (Page 8)

14 13
PROBLEM POSSIBLE CAUSE SOLUTION
Jar bottom does A vacuum has been Place the jar on the
not come off of jar formed blender and turn
counter clockwise until
jar is released from the
bottom
Liquid is leaking Gasket is either missing Check that jar is
from bottom of jar or not in place correctly assembled correctly
Appliance does Appliance is not Check that appliance
not turn on plugged in is plugged into
a working outlet
Mixture in blender Not enough liquid in Turn the blender off
does not seem to mixture being blended and use a rubber
be blending or too much ice spatula to redistribute
the food; add some
liquid and pulse the
mixture to aid in the
blending process
Herbs or bread are Blender jar, food to be Always make sure that
sticking to sides of chopped and blade are the jar, the blade and
blender and not not dry the food to be chopped
getting chopped are dry
Jar separates from Jar was twisted when When removing jar
bottom when being being removed from from blender base,
removed from base of blender simply lift up; do
blender. Liquid not twist
spills onto counter
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service
personnel.
CLEANING
1. Before cleaning, turn off and unplug the appliance.
2. Lift the jar by the handle off the power base.
3. Remove jar base by turning it counterclockwise until loose.
4. Remove the gasket and the blade assembly.
Caution: Blades are sharp, handle carefully.
5. Remove lid and lid cap.
6. Wash removable parts by hand or in the dishwasher. Place the jar on the
bottom rack and the rest of the parts on the top rack only.
Helpful Tip:
• For quick clean-up, combine 1 cup hot water and a drop of liquid dish soap
to the blender jar.
• Cover and blend on STIR for about 30 seconds.
• Discard liquid and rinse thoroughly.
Important:
• Do not place the jar parts in boiling liquids.
• Do not immerse the base in liquid. Wipe the unit base with a damp cloth
and dry thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and nonabrasive
cleaner.
Note: If liquids spill onto the power base, wipe with a damp cloth and dry
thoroughly. Do not use rough scouring pads or cleansers on parts or finish.
TROUBLE SHOOTING
BLP6600M 5/23/07 9:35 AM Page 14