Philips DC912-37 - Manual (Page 2)

1
2
3
4
5
6
7
In standby mode, press and hold PROG/SET TIME on the remote control.
Press VOLUME +/- (or VOL +/- on the remote control) to switch
between 12 hour and 24 hour display.
Press PROG/SET TIME on the remote control again to confirm.
➜ The clock digits flash on the display panel.
Press
VOLUME +/-
(or
VOL +/-
on the remote control) to set the hours.
Press
PROG/SET TIME
on the remote control again.
➜ The clock digits for the minutes flash.
Press VOLUME +/- (or VOL +/- on the remote control) to
set the minutes.
Press PROG/SET TIME on the remote control to confirm the time.
Tip
– See the User Manual for how to
connect other equipment to this
system.
– Use the supplied AC power
adaptor only! Using any other
power connection device may
damage your main set!
Setting the clock
1
2
Connect the AC power adaptor of the system.
Connect the AC power cord of the subwoofer to the AC outlet.
1
2
In case the wireless connection fails due to conflict or strong
interference etc., you may need the following procedures for
manual pairing:
1 In standby mode, press and hold 2; on the set for three seconds to
activate signal transmitting.
➜ “PAIR” flashes on the display screen.
2 Press and hold the PAIR button on the rear of the subwoofer for
three seconds to activate signal receiving.
➜ The LED indicator on the subwoofer flashes in blue and green
alternatively.
● If the connection succeeds, the display shows “PASS”.
● If the connection fails or the connection cannot be set up successfully
within 60 seconds, the display shows “FAIL”.
DC912_37_QSG_Eng 8/25/08, 10:31 2