Philips 32PF9996-37 - Manual (Page 11)

7
Autoprogram
Install mode
Install
Install
Start
Antenna
Automatic
Cable
& Select Autoprogram in the Install menu.
é Press the cursor down to select Install mode .
“ Press the cursor right.
Note: It is recommended to keep the predefined
Automatic way
of autoprogramming. In case of difficulties in autoprogramming
with the automatic method, choose for Antenna or Cable whether
antenna or cable signals are present.
When Automatic is selected, the TV will automatically
detect whether or not cable signal input is present.
When
Antenna is selected, the TV will detect antenna
signals and will search for all antenna TV channels available
in your local area.
When
Cable is selected, the TV will detect cable signals and
will search for all cable TV channels available in your local
area.
‘ Press the cursor down to select Install .
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (See
Channels in the TV menu, p. 15.)
( Press the cursor right.
§ The message Searching appears and the progress of
autoprogramming is displayed.
When Autoprogramming is complete, the puck navigates to
Stop. A message appears confirming the completion together
with the total number of channels found.
Note: when you navigate to Stop before autoprogramming is
complete, you are given the option to continue.
Available channels:
- with cable: max. from 1 to 125
- off air: max. from 2 to 69
Note: In case a particular channel is too weak for the
autoprogramming to identify, after installation is complete, you
should tune to that channel by using the digit buttons on the
remote control.
If the channel is not acquired, a message will appear that the
channel is not available.
Store TV channels