Philips 2000 series LED-LCD TV 39PFL2908 39" class-po - Manual (Page 19)

19 English
9
Use ◄► to select your preferred energy efficiency level, then press
OK.
10
Use ◄► to select your preferred sound setting, then press OK.
11
Press OK to finish Settings assistant.
• Network updates will appear after Connection test succeeds.
Use ◄► to select Yes, then press OK.
• When the initial setup is completed, the lowest memorized
channel with the confirmation message will be displayed on the
TV screen.
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram ➟ p.34
• You can add the desired cable and Analog channels
unmemorized by AutoProgram.
Weak channel installation ➟ p.34
• If you want to change to another language.
Language ➟ p.33
• If you want to change the country setting.
Country ➟ p.45
• If you want to change the location setting.
Location ➟ p.35
• If you want to change the network setting.
Network ➟ p.37
• If you want to restore the picture and sound setting.
Settings assistant ➟ p.27
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press
during autoprogram, this setup of TV channels will be cancelled.
• The initial AutoProgram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), select Autoprogram
again. ➟ p.34
Select the energy efficiency level you prefer.
Personal Energy saving
Select your preferred sound setting
Sound A Sound B Sound C
Store your preferences.
Cancel Store