Philips AJ300D-37B - Manual (Page 5)

POWER SUPPLY
Mains adapter
1 Connect the mains adapter to the set's DC 18V socket and to the power socket.
Helpful hints: To avoid damage to the set, use only the adapter supplied!
The type plate is located on the bottom of the set.
Remote control
Important!
• Before using the remote control, remove the insulation plastic tab as
shown in the figure.
• If the remote control does not function correctly or the operating
range is reduced, replace the battery with a new (CR2025) type
battery.
1. Pull the battery tray out as shown in the figure .
2. Replace a new battery according to polarity indication, and fully insert the
battery tray back to the original position.
- Batteries contain chemical substances, so they should be disposed
of properly.
- Perchlorate Material-special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 10 minutes when there is a power interruption
e.g. AC power failure. The complete clock radio and backlight illumination will be
switched off.
If power supply returns after 10 minutes and the display shows:
• clock time blinking - indicates you need to re-adjust the clock time.
BASIC OPERATION.
Switching on the system
• Press POWER.
™ The system will switch to the last selected source.
• Press TUNER/AUX or DOCK.
™ The system will switch to the selected source.
Switching the system to standby mode
• In any source mode, press POWER.
Switching off the volume temporarily
Press MUTE on the remote control to stop sound play-back instantly.
™ Playback will continue without sound and the display shows MUTE .
• To start sound playback you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Illumination brightness
Press REPEAT ALARM /
BRIGHTNESS CONTROL once or more.
• The brightness of the display can be adjusted:
Bright
➟
Low
➟
Off
➟
Bright .
SETTING THE CLOCK AND DATE
1. In any mode, press and hold TIME SET until clock digits flashes.
2. Press
2; to select 12 Hours/ 24 Hours mode.
3. Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.
4. Press TIME SET to confirm.
™ The clock digits for the minutes flash.
2 3
1
CAUTION
High voltage! Do not open.You run the risk of getting an electric
shock. The machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of
EMC or other unsafe operation.
AJ300D_37-Eng 6/10/08 15:29 Page 5