Philips DVDR600VR-37B - Manual (Page 72)

72 Rerecording (Tape Duplication)
• If you use the AUDIO and VIDEO
IN jacks on the back of Recorder
2, press CHANNEL
K / L to
select EXT2 at step 5. EXT2 will
appear on the TV screen.
• If you use the AUDIO and VIDEO
In jacks on the front of Recorder
2, press CHANNEL
K / L to
select CAM1 at step 5. CAM1
will appear on the TV screen.
• Unauthorized recording of
copyrighted television programs,
video tapes, or other materials
may infringe on the rights of
copyright owners and violate
copyright laws.
• If a program has copyright
protection, it may not record
clearly.
Helpful Hints
1 Make the connections shown above.
2 Recorder 1 will play your tape. Put a prerecorded tape into the
cassette compartment of Recorder 1. Press VCR to put the
unit in VCR mode if necessary.
3 Recorder 2 will record your tape. Insert a blank tape in the
cassette compartment of Recorder 2. Press VCR to put the
unit in VCR mode if necessary.
4 Turn on the TV and set it to channel 03. (To use channel 04
instead, see page 10.)
5 Point the remote control at Recorder 2. Press CHANNEL
K K/ L L to select EXT2 or CAM1. (See Helpful Hints at right.)
6 Press REC MODE to select SP or SLP as the tape recording
speed at Recorder 2.
7 Press RECORD I (VCR) on the front of Recorder 2 then
press PLAY B (VCR) on the front of Recorder 1.
To stop recording, press STOP C / EJECT A (VCR) on Recorder 1,
then press STOP C / EJECT A (VCR) on Recorder 2.
Recorder 1
Playing unit
Recorder 2
Recording unit
3. RF coaxial cable from the ANTENNA
OUT jack of Recorder 2 to the TV’s
ANTENNA IN jack
These instructions show you how to copy videotapes.The illustration uses two Recorders. Other VCRs or Camcorders may
operate differently.
2. Video cable from yellow
VIDEO OUT jack of
Recorder 1 to VIDEO IN
jack of Recorder 2
1. Audio cables from AUDIO OUT jacks (red and white) of
Recorder 1 to AUDIO IN jacks of Recorder 2
E9480UD_EN.qx3 05.1.8 4:16 PM Page 72