Philips 37PF9936-37 - Manual (Page 13)

9
AV3
L
AUDIO
R HDMI
HDMI (High Definition Multimedia Interface) connector
Connect the digital HDMI output of your HD device (e.g. DVD player, Set Top Box..) to the HDMI
connector of your TV.
Notes:
- Proper working is only guaranteed with HDMI compliant consumer products.
- Digital devices from different manufacturers have the possibility of differing output standards which may cause
difficulties for the television to properly display;
- If the set is cold, there may be a small “flicker” when the set is turned on. This is normal, there is nothing wrong
with the set.
HDMI is the leading new standard for Digital High Definition video
and audio interconnection. Eg. with a Digital Set top box, with
HDMI-equipped devices like a DVD-R, AV receiver...
Note: The HDMI connector does NOT support DVI devices with analogue
audio.
The HDMI connector allows
- the following TV and monitor display modes:
EDTV 640/720 x 480p
720 x 576p
HDTV 1920 x1080i
VGA
640 x 480 60 Hz
SVGA 800 x 600 60 Hz
XGA 1024 x 768 60 Hz
- uncompressed HD content
- encrypted or non encrypted signals.
According to where you connected the accessory devices, press
• AV+ followed by digit ‘ 1 ’ to select AV1
• AV+ followed by digit ‘ 2 ’ to select AV2
• AV+ followed by digit ‘ 3 ’ to select REAR for a device connected
to the rear or to the side (according to the type of TV you've
purchased), see p. 6
• AV+ followed by digit ‘ 4 ’ to select HD-A for a HD-A device
connected to AV3 , see p. 8
• AV+ followed by digit ‘ 4 ’ again to select HD-D for a HD-D device
connected to AV3 , see p. 9
• AV+ followed by digit ‘ 5 ’ to select PC-A for a PC connected to
AV3 , see p. 8
• AV + followed bij digit ‘ 1 ’ and followed by P+ to select CVI .
Note: When in HD or PC mode, first press the TV button to return to TV
mode or to select AV1 , AV2 or REAR again.
7 8 9
0
ACTIVE SLEEP
AUTO AUTO
a M
CONTROL PIP TIMER SAP
AV+ -
AV+
To select connected devices
2355.4 en 02-11-2004 14:19 Pagina 9