Philips 23PF5320-28 - Manual (Page 7)

7
Accessory device equipped with
component video outputs
1
2
3
Wall outlet
4
1
2
3
1
2
AV Player with A/V connectors
1
2
Wall outlet
3
VCR, DVD P
LAYER
,
OR OTHER
D
EVICES WITH
RCA C
ONNECTORS
The AV IN jacks on the rear of the LCD TV enable quick
connections of other equipment. Connect a DVD player, VCR
Video Game, Camcorder, etc., to these jacks. To view the
material playing on the other equipment, set the LCD TV to its
AV mode.
Using an RCA-type Video and Audio cable (usually marked yellow, red,
and white), connect the VCR’s Video and Audio Out jacks to the TV’s
Video and Audio In jacks.
Plug the power cable into AC inlet on LCD TV set. Plug the power
cable into an outlet and switch TV set on.
Use AV+ button on the remote control to select AV1 (or AV2,
S-Video if you use the different jacks for this hookup) to watch VCR.
Note:
1. If your VCR equipped with a S-Video Out jack, uses S-Video
connection for better picture detail and clarity. Use the S-Video cable
to connect the VCR’s S-Video Out jacks to the TV’s S-Video In jacks.
2. When you watch programs using VCR, it’s recommended to select
SOFT Mode via Auto picture.
3. You can also use the Video and Audio jacks in AV/S-VIDEO (AV1) and
COMPONENT SD/AV (AV2) located on the rear of the TV to
connect your VCR or other Video Devices.
4. If your DVD Player is equipped with Component (Y, Pb, Pr) Output
Jacks, please refer to “Connecting a DVD Player or other Video
Equipments with Component Video Connectors” section for use
of Component Video Connection for highest color and picture
resolution in video playback.
DVD P
LAYER OR OTHER
V
IDEO
D
EVICES
WITH
C
OMPONENT
V
IDEO
C
ONNECTORS
Component Video Input (Y, Pb, Pr) provide the highest possible
color and picture resolution in the playback of digital signal source
material, such as with DVD player.
Using a Component Video cable (not supplied), connect the DVD
player’s Y, Pb, Pr jacks to the Y, Pb, Pr jacks on the TV. Use the
COMPONENT SD/AV (AV2) connections.
Note: The Component (Y, Pb, Pr) Video Input in COMPONENT
SD/AV (AV2) connections can display SD (480i/576i) image only. If your
DVD player can output Progressive scan or HD (High Defi nition) image,
please refer to “Digital TV Receiver, or a Digital Satellite Receiver with
HD (High Defi nition) Output” in next section.
Using an AUDIO cable, connect the DVD player’s AUDIO OUT
jacks to the TV’s AUDIO IN jacks in COMPONENT SD/AV (AV2)
connections.
Plug the power cable into AC inlet on LCD TV set. Plug the power
cable into an outlet and switch TV set on.
Use AV+ button on the remote control to select COMPONENT to
watch DVD.
Note: The Y, Pb, Pr jacks do not provide audio, so audio cables
must be connected to provide sound.
3
4