Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 100)

82 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Configuring IP parameters – Layer 3 Switches
• Although the DHCP server may provide multiple addresses, only one IP address is installed at a
time.
• This feature is not supported together with DHCP snooping.
The following configuration rules apply to flash image update:
• To enable flash image update (ip dhcp-client auto-update enable command), also enable
auto-configuration (ip dhcp-client enable command).
• The image filename to be updated must have the extension .bin.
• The DHCP option 067 bootfile name will be used for image update if it has the extension .bin.
• The DHCP option 067 bootfile name will be used for configuration download if it does not have
the extension .bin.
• If the DHCP option 067 bootfile name is not configured or does not have the extension .bin,
then the auto-update image will not occur.
How DHCP Client-Based Auto-Configuration and flash image update works
Auto-Configuration and Auto-update are enabled by default. To disable this feature, refer to
“Disabling or re-enabling Auto-Configuration” on page 86 and “Disabling or re-enabling
Auto-Update” on page 86, respectively.
The steps of the Auto-Configuration and Auto-update process are described in Figure 9 , and in the
description that follows the flowchart.