Philips 7616X-45 - Manual (Page 9)

Once A Month: Razor Heads
◗ Do not mix up the cutters and combs as the
shaving persormance may be adversely
affected for several weeks before optimal
shaving performance is restored.
1 Turn razor OFF, remove the charging plug
from the outlet and cord from the razor.
C
2 Press the razor head release button (1),
open and lift off the razor head assembly (2).
C
3 Turn the center wheel counterclockwise
(1) and remove the retaining frame (2).
4 Remove and clean one set of cutters and
combs at a time.
C
5 Separate the cutter from the comb and
rinse clean under hot water.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C
6 Replace the set back into the Head
Assembly so that the ‘wings’ on the comb
fit within the brackets located towards the
center of the assembly.
ENGLISH 17
◗ The set will only fit into the Razor Head
Assembly so that the ‘wings’ on the comb fit
within the brackets located towards the
center of the assembly.
◗ Make sure tat the two pointy edges of the
head fit exactly into the recesses.
7 Repeat the process for the other two sets
of cutters and combs.
8 Replace the frame.
C
9 Press down (1) and turn wheel clockwise
(2) until it locks into place.
10 Replace the Razor Head Assembly back on
razor.
◗ If the razor heads have been properly
inserted, a shiny circle is visible in the middle
of the razor head assembly.
Once A Month: Razor Heads
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Norelco Razor Cleaner, Model RC 1776, or
alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).This helps prevent
wear of the shaving heads.
ENGLISH 16