Philips VRB615AT - Manual (Page 5)

Before Using Your VCR 5
Putting Batteries in the Remote Control
3
Replace the battery compartment lid.
Using the Remote Control
• Do not put objects between the remote control and the VCR.
• Point the remote control at the VCR’s remote sensor, then press
the VCR button before pressing other VCR operation buttons.
• Point the remote control at the TV, then press the TV button
before pressing other TV operation buttons.
• Point the remote control at the Cable Box/DBS, then press the
CBL/DBS button before pressing other Cable Box/DBS operation
buttons.
• The remote control and its batteries
are supplied.
• Do not mix alkaline and manganese
batteries.
• Do not mix old and new batteries.
• A thin, plastic cover may protect the
front panel of your VCR. Before
using the VCR, lift a corner of the
plastic, then peel it off.
Helpful Hints
VCR Maintenance/Video Head Cleaning
• Remove any light adhesive stick-on notes from the video cassette
before putting the cassette in the VCR. Removable labels can jam
the VCR.
• Periodic maintenance is required to maintain your VCR’s perfor-
mance. Your VCR automatically cleans the video heads each time
you insert a tape. However, the heads may become dirty. “USE
CLEANING CASSETTE” may appear on the screen, and “U:01”
will appear on the VCR display panel. These messages will appear
briefly every seven seconds during tape playback. The messages will
appear until you adjust the tracking, remove and reinsert the tape,
or clean the heads. Details are on page 60.
The video heads eventually will require professional cleaning or
replacement. Only an authorized service center should perform
this service.
Erase Protection
Video cassettes have record tabs to ensure that recordings are
not erased accidentally.
1
To prevent accidental erasure, break off the tab with a
screwdriver.
2
To record again, cover the hole with cellophane tape.
1
To remove the battery compartment lid, push in the tab,
then pull up the lid.
2
Place two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
1
2
1
2
3