Philips SHB9100-28 - Manual (Page 9)

10
Turn the headset
off.
Press and
hold for
more than 4
seconds
- 1 long beep
- 1 long white
flash
Play or pause
music.
Tap
1 short beep
Pick up or
terminate a call.
Tap
1 short beep
Reject a call.
Hold
1 short beep
Redial the last
number.
Double tap 1 short beep
Switch caller in
a call.
Double tap 1 long beep
Transfer a call
to your mobile
phone. (This
function is
available if your
mobile phone
supports this
feature.)
Hold
for
more than 4
seconds
1 long beep
Adjust volume. Slide up and
down VOL
+/-
1 short beep
Skip forward. Tap 1 short beep
Skip backward. Double tap 1 short beep
Mute/unmute
the microphone
in a call.
Tap 1 short beep /
2 short beeps
Activate voice
dialing
Double tap 2 short beeps
before dial
tone
Other status and indicators
Headset Status Indicator
The headset is connected
to a Bluetooth device, while
the headset is in standby
mode or while you are
listening to music.
Blue LED flashes
every 8 seconds.
The headset is ready for
pairing.
LED flashes
whiteand
bluealternately.
4 Use the headset
Connect the headset to a
mobile phone
1
Turn on your mobile phone.
2
Press and hold to turn the headset on.
The blue LED is on. »
The headset is reconnected to the last »
connected device automatically. If the
last one is not available, the headset
tries to reconnect to the penultimate
connected device.
Note
If you turn the mobile phone on or its • Bluetooth feature
after turning the headset on, connect the headset from
the Bluetooth menu on your mobile phone.
Automatic power saving
If the headset cannot find any Bluetooth device
to connect to in range within five minutes, it
powers down automatically to save the battery
life.
Use your headset
Task Operation Sound or LED
Indicator
Turn the headset
on.
Press and
hold for
more than 4
seconds
1 short beep
- 3 white
flashes: Battery
low < 25%
- 2 white
flashes: Battery
level < 50%
- 1 blue flash:
Battery level >
50%
EN