Philips MCD515-37 - Manual (Page 37)

37
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1
In standby mode, press and hold TIMER SET 3
( TIMER on the remote) for more than three
seconds.
➜
"
SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours and press TIMER SET 3 (TIMER on
the remote) to confirm.
➜ The minute digits flash on the display panel.
3
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes and press TIMER SET 3 (TIMER on
the remote) to confirm.
➜ " ON" or "OFF" flashes.
4
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to activate or
deactivate the timer and press TIMER SET 3
( TIMER on the remote) to complete the
setting.
➜
Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜
The selections are as follows (time in
minutes):
0FF ™ 10 ™ 20 ™ 30 ™ 40 ™ 50 ™ 60 ™
70 ™ 80 ™ 90™ 0FF
➜
"
SLEEP XX" is displayed. "XX" is the time in
minutes.
2
When you reach the desired length of time, stop
pressing the
SLEEP button.
To deactivate the sleep timer
● Press SLEEP repeatedly until " 0FF" is displayed,
or press ECO POWER/STANDBY ON y.
T H E A T H R E 5
TUNING PRESET
DSC
PROGRAM MODE ANGLE A-B
IS
pg001-pg042_MCD515-37-Eng 2006.2.27, 16:21 37