Philips AZ1325-17B - Manual (Page 4)

ACCESSORIES
1 x AC power cord
1 x Remote Control (For AZ1325 only)
TOP AND FRONT PANEL (See 1)
1 OPEN • CLOSE– opens/closes the CD door
2 PROG
CD: - programs tracks and reviews the program;
Tuner: - programs preset radio stations.
3 MODE - selects different play modes: e.g. REPEAT
or SHUFFLE (random) order.
4 VOLUME 3 , 4 - to adjust volume level.
PRESET + ,
-
(up, down) - selects a preset radio
station.
5 Display - shows the status of the set.
6 2; - starts or pauses CD playback.
9 - to stop playback or erase a CD program.
SEARCH
∞ , §
CD: - searches backward and forward within a track;
- skips to the beginning of a current track/
previous/ later track.
RADIO: - (down, up) tunes to radio stations.
7 DBB (Dynamic Bass Boost) - activates a more vivid
bass response.
8 POWER slider - selects CD/ AM / FM / OFF
function and also the power off switch (OFF).
BACK PANEL (See 1)
9 Telescopic antenna - improves FM reception.
0 p - 3.5 mm stereo headphone jack.
Note: The speakers will be muted when headphones
are connected to the set.
! Battery compartment - for 6 batteries, type
R-14, UM2 or C-cells.
@ AC MAINS - inlet for power cord.
REMOTE CONTROL (For AZ1325 only)
1 VOLUME 3 , 4 - adjusts volume level.
2 SHUFFLE - plays all CD tracks in random order.
3 2; - starts or pauses CD playback.
4 SEARCH 5 , 6 - searches backwards/
forwards within a track.
5 PRESET + ,
-
(up, down) - selects a preset radio
station.
6 TUNING ∞ , § (down, up) - tunes to tuner stations.
7 9 - to stop playback;
- erases a CD program.
8 ¡ , ™ - skips to the beginning of a current track
previous/ subsequent track.
9 REPEAT - repeats a track /program/ entire CD.
CAUTION
Use of controls or adjustments or
performance of procedures other than
herein may result in hazardous radiation
exposure or other unsafe operation.
POWER SUPPLY
Whenever convenient, use the AC power supply to
conserve battery life. Make sure you remove the
power plug from the set and wall outlet before
inserting batteries.
Batteries (not included)
• Insert 6 batteries, type R-14, UM-2 or C-cells,
(preferably alkaline) with the correct polarity. (See 6)
• Remote control (For AZ1325 only)
Insert 2 batteries, type AAA, R03 or UM4
(preferably alkaline). (See 8)
IMPORTANT!
• Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Batteries contain chemical substances, so
they should be disposed of properly.
Using AC Power
1. Check if the AC power supply, as shown on the
type plate located on the bottom of the set,
corresponds to your local power supply. If it does
not, consult your dealer or service center.
2. Connect the power cord to the outlet.
3. To disconnect the power supply, unplug the set
from the outlet.
The type plate is located on the bottom of the
set.
BASIC FUNCTIONS
Switching on and off and selecting function
1. To switch on, adjust the POWER slider to select:
CD, AM, FM function, and operate the respective
function controls.
2. To switch off, adjust the POWER slider to select
OFF .
Note : The DBB setting, tuner presets and the
volume level (maximum to 20) will be retained in the
set's memory.
Adjusting volume and sound (See 2)
1. Adjust the volume with the VOLUME controls.
™ Display shows the volume level in number from
0-32.
2. Press DBB once or more to select dynamic bass
boost on or off.
™ Display: shows when activated.
English CONTROL POWER SUPPLY POWER SUPPLY