Philips MC235B-37 - Manual (Page 15)

15
English
Radio Reception
Tuning to radio stations
1 Press SOURCE to select TUNER.
➜ TUNER is displayed briefly.
2 Press BAND (or TUNER on the remote
control) once or more to select your waveband.
(FM/ AM)
3 Press and hold TUNE
à or á.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning:
SEARCH.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNE à or
á briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only program
stations which are not in the memory already.
1 Press PRESET
¡ or ™ to select the preset
number where programming should star t.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2 Press PROGRAM for more than 2 seconds to
activate programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM. The last preset
automatically stored will then be played.
Manual programming
1 Tune to your desired station (see Tuning to radio
stations).
2 Press PROGRAM to activate programming.
➜
PROGRAM
flashes in the display.
3 Press PRESET
¡ or ™ to allocate a number
from 1 to 40 to this station.
4 Press PROGRAM again to confirm the setting.
➜
PROGRAM disappears, the preset number and
the frequency of the preset station are shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESET ¡ or ™ until the desired preset
station is displayed.