Philips MCD908-37B - Manual (Page 37)

English
37
Radio Reception
Tuning to radio stations
1
Press STANDBY-ON B (B on the remote)
to switch on the last selected source.
2
Press SOURCE (TUNER on the remote) to
select TUNER mode.
3
Press TUNER on the remote again to select
the desired band: FM or AM
4
Press and hold ¡ / ™ (а / б on the remote)
until the frequency indication starts to change,
then release.
➜ The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press ¡ / ™ (а / б
on the remote) briefly and repeatedly until an
optimal reception is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic progamming
● Press PROG on the remote for more than two
seconds to activate programming.
➜ All available stations are programmed.
Manual progamming
1
Tune to your desired radio station (refer to
“Tuning to radio stations”).
2
Press PROG on the remote.
➜ ”PROG” icon flashes.
3
Press PRESET+/- (or ¡ / ™ on the remote) to
select the desired preset number.
➜ If “ PROG” icon goes off before you select the
desired preset number, press PROG on the
remote.
4
Press PROG on the remote again to store the
radio station.
● Repeat steps 1-4 to store other radio stations.
Other Functions
Listening to preset radio stations
●
In tuner mode, press PRESET+/- (or
¡ / ™ on
the remote) to select the desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.