Philips 8020X-33 - Manual (Page 11)

ENGLISH
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
5 Separate the cutter from the comb and
clean with a small brush or rinse clean
under hot water.
6 Replace the cutter back onto the Razor
Head Assembly making sure the blades are
pointing upwards.
C
7 Place the razor head comb back onto the
Razor Head Assembly.
Be sure to replace the comb back into the
original razor head before cleaning the next set.
C
8 Turn the razor head counterclockwise
until it locks into place.
9 Repeat the process for the other two sets
of cutters and combs.
C
10 Replace Razor Head Assembly back on
razor and push down (you will hear a
click).
The Razor Head Assembly will only fit correctly
in one position on razor. Make sure to align the
2 shaving lotion dispensing holes on the Razor
Head Assembly with the 2 shaving lotion tubes on
the razor.
20 ENGLISH
Replacing Cartridges
◗ For hygienic reasons, it is recommended to
replace the shaving conditioner cartridge
each time you start a new shaving conditioner
bottle.
◗ A new empty cartridge is supplied with each
new NIvEA FoR MEN Shaving Conditioner
bottle (Model HS800).
Shaving Conditioner Cartridge
C
1 Remove the shaving conditioner cartridge
from the back of razor.
C
2 Insert the hinge at the top of the new
shaving conditioner cartridge into the slot
in the rim of the razor back (1). Then
press the bottom part of the cartridge
with your thumb (2) to attach the
cartridge to the razor. You will hear a
‘click’.
3 The shaving conditioner cartridge is
now ready to be filled (see ‘Filling Razor
Cartridge’ section).
21
6
6