Philips 24PFL4508-F7 - Manual (Page 17)

17 English
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram ➟ p.24
• You can add the desired cable and Analog channels
unmemorized by autoprogram.
Add channels ➟ p.25
• If you want to change to another language.
Language ➟ p.31
• If you want to change the location setting.
Location ➟ p.31
• If you want to restore the picture setting.
Settings assistant ➟ p.23
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press
or during autoprogram, this setup of TV channels will be
cancelled.
• The initial autoprogram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), select Autoprogram
again. ➟ p.24
• If there is no signal Input from the antenna terminal and no operation for several
seconds after you Turn On the unit, helpful hints appears. Follow the instructions listed
on the TV screen.
Initial setup
Retry
Later
Skip OK Select
No channel is registered.
Try Autoprogram again?
Verify that you have a cable connected to the “ANTENNA IN” jack
on the back of the TV, the channel installation process
searches this connection. If you are using a cable or satellite
box, please confirm the input which you have connected to
the box and press “SOURCE” key on the remote control to
select the appropriate source input.