Philips 60PP9363H-17B - Manual (Page 7)

2 Press the PIP CH DN/UP buttons to tune to channels
in the PIP window.
If you press and hold the PIP CH UP button for three sec-
onds, the set will automatically perform a forward scan for
channels. Press and hold the PIP CH DN button for three
seconds, and the set will automatically perform a back-
ward scan for channels. Auto scanning will stop if you
press any key, and it will also stop upon reaching the
channel at which scanning began.
3 Press the PIP POSITION button to move the PIP win-
dow from corner to corner on the TV screen.
4 With PIP on the TV screen, press the SWAP button to
swap the main and PIP pictures. Press SWAP again to
swap the pictures back.
NOTE: The CVI source is not accessible in the PIP win-
dow, so it cannot be swapped between the main screen and
PIP.
5 Press the FREEZE button to stop motion within the
PIP window.
The FREEZE button allows you plenty of time to write
down on-screen information such as phone numbers or
addresses.
6 Press the PIP on/off button, multiple times if necessary,
to remove the PIP window from the screen.
7
2 1 3
5 4 6
8 7 9
0
TV
SWAP PIP CH
DN UP
FREEZE
SOUND
MUTE
SURF A/CH
POWER
PICTURE
STATUS/
EXIT
VCR ACC
MENU/
SELECT
VOL CH
TV/VCR
ACTIVE
CONTROL
FEATURES
TIMER
AutoLock
PIP
CLOSED CAP
FORMAT
TINT
FEATURES
TINT 44
PIP
1
4
FEATURES
TINT
COLOR
COLOR 44
PIP
2,3
PIP
2 1 3
5 4 6
8 7 9
0
SURF A/CH
POSITION
TV/VCR 1,6 3
SWAP
FREEZE
Ski Vacations
P.O. Box 55512
Anytown, USA 87654
1-800-555-1212
To prevent uneven picture tube aging, do not leave stationary images
on screen for extended periods of time. Vary your picture viewing.
See page 60 in the Directions for Use manual.
W
ARNING
A
DJUSTING
PIP T
INT AND
C
OLOR
T he Picture-in-Picture (PIP) TINT control allows you to adjust
the PIP picture to obtain natural skin tones. The COLOR con-
trol allows you to fine tune the color.
1 Press the MENU/SELECT button. The onscreen menu
appears. Then press the CURSOR RING DOWN twice to
highlight FEATURES.
2 Press the CURSOR RING RIGHT to enter the FEA-
TURES submenu. Then press the CURSOR RING DOWN
repeatedly until the PIP item is highlighted. Press the CUR-
SOR RING RIGHT to enter the PIP submenu.
3 Press the CURSOR RING RIGHT or LEFT to adjust the
TINT or COLOR to the desired level.
4 Press the STATUS/EXIT button to exit the menu.