Philips AT790-40 - Manual (Page 10)

ENGLISH
C
4 Clean outside of Razor Head Assembly by
running under hot water.
5 Close the Razor Head Assembly and shake
off excess water.
Be careful not to hit the shaving unit against
anything while shaking off excess water.
6 Open Razor Head Assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue. This could damage the
shaving heads.
w If you used foam or gel to shave, make sure to
rinse all of it off to prevent residue build-up
from clogging shaving heads.
w If the shaving unit becomes detached from the
razor, you can easily reattach it.
w You may also clean the hair chamber without
water by using the supplied brush.
Extra-thorough Cleaning Method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn razor OFF, remove the charging plug
from the outlet and power cord from the
razor.
18
ENGLISH
C
2 Press the Razor Head Release Button to
open the Razor Head Assembly.
C
3 Pull the shaving unit off the razor.
C
4 Turn the lock counterclockwise to unlock
(A) and remove the retaining frame (B).
C
5 Remove and clean one set of cutters and
combs at a time.
C
6 Separate the cutter from the comb and
clean it with the brush supplied. Use the
short bristled side of the brush.
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
19
A
B