Philips DVDR3400-37B - Manual (Page 67)

English
67
Problem (General) Solution
Troubleshooting
(continued)
No sound.
No TV signal received from
the recorder.
A TV channel installed
during the DVD recorder’s
automatic TV channel
search is fuzzy or distorted.
Unable to eject disc tray.
The contents of the USB
fl ash drive cannot be read.
Slow operation of the USB
fl ash drive.
No HDMI audio output.
No HDMI video output.
– Check the audio connections, the red and white jacks. Read
chapter “Step 1: Basic Recorder Connections - Connecting
the audio cables” for details.
– Set the Digital output correctly, based on the equipment
you connected to the DVD recorder. Read chapter “DVD
Setup Menu Options – PLAYBACK settings – Digital Audio
Output” for details.
– Have your antenna or cable TV signal checked.
– Install the TV channel. Read chapter “Step 3: Installation
and Setup - Setting your TV channel programs” for details.
– Check the video connection between the DVD recorder
and the TV.
– You can further fi ne-tune the signal of the TV channel.Read
chapter on “DVD Setup Menu Options - CHANNEL SETUP
Settings – Modify Channel Information.”
– Press CH +/– to search for the same TV channel which may
have a clearer picture.
– Exit from any system or recording setup menu until you see
the Philips wallpaper on the screen.
– Press STOP to stop any playback or recording. Then press
EJECT on the set or press OPEN/CLOSE on the remote
control to eject the disc tray.
– The USB fl ash drive format is not compatible with the
system.
– Drive is formatted with a different fi le system which is not
supported by this DVD system (e.g. NTFS.)
– Large fi le size or high memory USB fl ash drive takes longer
time to read and display on the TV.
– You will not hear any sound from the HDMI output if the
source device is only DVI/HDCP (High-bandwidth Digital
Content Protection)-compatible.
– It is not possible to output SACD or copy-controlled DVD-
Audio sources from the HDMI connection.
– HDMI connection can only be made to HDMI-equipped
devices with HDCP (High Bandwidth Digital Content
Protection.) If you wish to connect to a DVI connector
(equipped with HDCP), you will need a separate adaptor
(DVI to HDMI.)
– Make sure the resolution of this DVD system matches the
device you have connected using the HDMI. See HDMI
setting.
1_dvdr3400_37_eng_22151a.indd 67 1_dvdr3400_37_eng_22151a.indd 67 2007-02-26 11:54:30 AM 2007-02-26 11:54:30 AM