Philips Micro Hi-Fi System MCM195 MP3 - Manual (Page 13)

13
English
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press 2 STANDBY ON or SOURCE.
➜ The system will switch to the last selected
source.
● Press CD, TUNER or TAPE on the remote
control.
➜
The system will switch to the selected source.
To switch the system to standby mode
●
Press 2 STANDBY ON on the system or
remote control.
●
If in tape mode or recording mode, press
STOP•OPEN Ç0 first.
➜ The volume level (up to a maximum volume
level of 20), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
Adjusting volume and sound
1
Turn the VOLUME control anti-clockwise to
decrease or clockwise to increase volume on the
system (or press
VOL -/+ on the remote
control).
➜
Display shows the volume level
VOL and a
number from 0-32.
2
Press DSC repeatedly to select the desired
sound effect: JAZZ / POP / CLASSIC / ROCK.
3
Press DBB to switch bass enhancement on or
off.
➜ Display shows: if the DBB is activated.
4
Press INCREDIBLE SURROUND (IS on
the remote control) to switch the surround
sound effect on or off.
➜ Display shows: if activated.
Note:
– The effect of INCREDIBLE SURROUND may
vary with different types of music.
5
Press MUTE on the remote
control to interrupt sound
reproduction instantly.
➜
Playback will continue
without sound.
● To activate sound reproduction you can:
– press
MUTE again;
– adjust the volume controls;
– change source.
DISPLAY/BAND
TAPE MUTE
LE PROGRAM
PG 001-022_MCM195_37-Eng 2005.5.20, 5:00 PM 13