Philips Norelco AquaTouch Series 4000 wet & dry electric shaver AT811 DualPrecision heads Flex & Float system 50 min shaving 1 hour charge AquaTech wet & dry technology with Aquatec wet and dry and Pop-up trimmer - Manual (Page 8)

15 14
ENGLISH
How To Shave With An Electric Razor
C
w This symbol on the razor indicates that
the razor can be used in both the bath and
shower.
w The razor will not operate while power cord
is connected to an electrical outlet.
w Use this razor for its intended household use
as described in this manual.
w Shaving with a clean face gives the best results.
Shaving
C
1 Turn razor ON by pressing the on/off
button once. Shave against the direction of
beard growth using circular movements.
2 Stretch your skin with your free hand so
blades can lift and cut whiskers. Gently
press razor to skin so the floating heads
can follow the contours of your face.
DO NOT press too hard. Too much
pressure can pinch the skin into the combs.
3 Turn razor OFF by pressing the on/off
button once.
4 Clean the razor after each use (see
chapter ‘Cleaning’).
C
5 Put the Protective Cap on the razor to
protect razor heads.
ENGLISH
Wet Shaving
You can also use the razor on a wet face with
shaving foam or gel.
C
1 Apply some water to your skin.
C
2 Apply shaving foam or gel to your skin.
3 Rinse the shaving unit under the tap
to ensure that the shaving unit glides
smoothly over your skin.
4 Press the on/off button once to switch on
the razor.
C
5 Move the shaving heads in circular
movements over your skin.
NOTE: Rinse the razor under the tap regularly to
ensure that it continues to glide smoothly over
your skin.
6 Turn razor OFF. Dry your face and
thoroughly clean the razor after each use
(see chapter ‘Cleaning’).
NOTE: Make sure you rinse all foam or gel off the
razor.
C
7 When razor is thoroughly dry, put the
Protective Cap on the razor to protect
heads.