Philips 27PT543F - Manual (Page 8)

8
CABLE
IN
TO
TV VIDEO
OUT
L R
AUDIO
OUT
3 4
OUTPUT
CH
TO TV CABLE
IN
3
1
2
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in
Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
24
L/Mono
Monitor out
VIDEO
S-VIDEO
AV1 in
Y
Pb
Pr
AV2 in
AUDIO
R
COMPONENT VIDEO INPUT
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in
Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
4
5
6
OUTPUT
CH
3 4
Cable Box Connection (RF Input/Output Only):
Jack Panel Back of Cable Box
Cable Signal
IN from the
Cable
Company
Round 75 Ω
Coaxial Cable
Jack Panel Back of TV
Cable Box Connection (with Audio/Video Outputs):
Cable Signal IN from
the Cable Company
Jack Panel Back
of Cable Box
Cable Box with
Audio/Video Outputs
RCA type Audio
Left and Right
Cables
Jack Panel Back of TV
I f you cable signal uses a cable box or
decoder, follow the easy steps below to
complete the connection.
Cable Box (w/RF In/Outputs):
This connection will NOT supply Stereo sound
to the TV. The sound from the cable box will
be mono.
1 Connect the open end of the round
Cable Company supplied cable to the
cable signal IN(put) plug on the back
of the Cable Box.
2 Using a separate round coaxial cable,
connect one end to the OUT(put) (TO
TV) plug on the back of the Cable
Box.
3 Connect the other end of the round
coaxial cable to the 75 Ω input on the
back of the television. Screw it down
finger tight.
NOTE: Be sure to set the OUTPUT CHAN-
NEL SWITCH on the back of the cable box to
CH 3 or 4, then tune the TV to the correspon-
ding channel. Once tuned, change channels at
the cable box, not the television.
Cable Box (w/Audio/Video
Outputs):
This connection will supply Stereo sound to the
TV.
4 Connect the open end of the round
Cable Company supplied cable to the
cable signal IN(put) plug on the back
of the Cable Box.
5 Using a RCA type Video Cable, connect
one end of the cable to the Video (or
ANT, your cable box may be labeled dif-
ferently) Out jack on the cable box and
the other end to the AV1 Video Input on
the TV.
6 Using a RCA type Audio Left and Right
Cable, connect one end to the left and
right Audio Out L & R jacks on the
cable box. Connect the other end to the
AV1 Audio L & R Input jacks on the TV.
NOTE: Use the Channel +, or – buttons on the
TV remote control to tune to the AV1 channel
for the cable box signal. Once tuned, change
channels at the cable box, not the television.
B
ASIC
C
ABLE
B
OX
/D
ECODER
C
ONNECTION
RCA type Video Cable