Philips AZ1308-37B - Manual (Page 6)

CD/MP3 Player
2 When you recognize the passage you want,
release TUNING
∞/ § to resume normal
playback.
Helpful hints:
– When your searching reaches the end of the
last track, the CD/MP3 goes to stop mode.
Programming track num-
bers
You may store up to 20 tracks (for MP3: 10
tracks) in the desired sequence. If you like,
store any track more than once.
1 In the stop position, press TUNING ∞ or
§ to select your desired track number.
For MP3: First press ALB/PRE +/- once or
more to find your album.
2 Press PROG to store the desired track
number.
➜ “PROG” is displayed, and display briefly
shows current program sequence, then
the currently stored track number.
(see
5 6)
➜ “For MP3: The current album number is
also displayed.
• If you attempt to program without first
selectig a track, display will show
N NO OS SE Ebriefly,
then the total track number.
3 Repeat steps 1 to 2 to select and store all
desired tracks in this way.
➜ If you attempt to store more than 20
tracks (for MP3: 10 tracks), no track can
be stored and the display shows
F Fu uL LL L.
4 To play your program, press 2;.
To review your program
In the stop position, press PROG to view the
first program information, then press PROG
again to view the next program information.
Repeat the above to view all the program
stored.
➜ Each time the display shows the program
sequence (
P Pr rO Og g X) briefly, then the program
track number (see 5 6).
To erase a program
You can erase a program by:
– pressing
9 (twice during playback or once in
the stop position);
– selecting TUNER or OFF position;
– opening the disc door.
➜ Display: PROG disappears.
Different play modes:
REPEAT and SHUFFLE
(See
7 8)
You can play the current track or the whole
disc repeatedly, and combine REPEAT modes
with PROGRAM.
REP – plays the current track continuously.
REP ALL – repeats the entire CD/program
SHUF – plays all the tracks in random order
• Selection of shuffle play is not available in the
program mode.
1 To select play mode, press MODE once or
more.
➜ The display shows selected play mode.
2 Press 2; to start playback if in the stop/pause
position.
➜ The disc will play automatically around
few seconds later when SHUF mode is
selected.
3 To return to normal playback, press MODE
repeatedly until the modes are no longer dis-
played
.
– You can also press 9 to cancel your play
mode.
Maintenance & safety (See 9)
CD player and CD handling
• If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
• The lens of the CD player should never be
touched!
• Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
• Always close the CD-tape door to avoid dust
on the lens.
• To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
• Never write on a CD or attach any stickers
to it.
Safety information
• Place the set on a flat, hard and stable surface
so that the system does not tilt.
• Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
• The apparatus shall not be exposed to drip-
ping or splashing.
• Adequate ventilation with a minimum gap of
15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
• Do not cover the ventilation openings with
items such as newspapers, table-cloths, cur-
tains, etc.
• No objects filled with liquids, such as vases,
shall be placed on the apparatus.
• No naked flame sources, such as lighted can-
dles, should be placed on the apparatus.
• The mechanical parts of the set contain
self-lubricating bearings and must not be oiled
or lubricated.
• To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.