Philips VRX360AT99 - Manual (Page 36)

VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
36 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
● Channels are programmed (page 12).
● The VCR Plus+ and Cable/TV channel numbers are entered
(pages 34-35).
● The clock is set (page 15).
● There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
● The VCR light appears on the display panel of the VCR. If it
does not, press the VCR/TV button once.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may return to step 1.
1
Press the VCR button, then the VCR PLUS+/ENTER but-
ton on the remote control. The on-screen display shown below
will appear.
2
Use the Number buttons to enter the PlusCode program-
ming number of the program you wish to record (this number is
different for every program, and it can be four to eight digits long).
Finally, press the VCR PLUS+/ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR +
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
3
To record the program once, press the Number 1 button to
select ONCE. To record the same program every day from
Monday through Friday, press the Number 2 button to select
DAILY. To record the same program every week on the same
day (such as every Saturday), press the Number 3 button to
select WEEKLY.
1
2
• ALL PROGRAMS IN USE will appear
on-screen at step 1 if all timer
recording slots are full. See page 33
to clear a timer recording slot.
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+/ENTER button, the number
you entered was incorrect or too
short. If this happens, enter the cor-
rect number.
• CLASH may flash on the screen at
step 2 or at step 5. This means that
the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out.
• If the end of the tape is reached
during a timer recording, recording
will stop. The VCR will eject the tape
and turn itself off.
Helpful Hints
3
VCR PLUS+ PROG.
1 ONCE
2 DAILY
3 WEEKLY
TO SELECT PUSH NO. SHOWN
TO END PUSH EXIT
REW
PLAY
POWER
VCR PLUS+
/ENTER
SPEED
VCR
TIME SEARCH
TV
MUTE
CABLE
/DSS
VCR/TV
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY SLOW PAUSE/STILL
MENU CLEAR EJECT
STOP
F.FWD – +
1 2 3
4 5 6
7 8 9
0 +100