Bushnell 78-9470 - Manual (Page 3)

4. Attach Accessory Tray
Locate the
Accessory Tray (8). Using the accessory tray bolts, wingnuts and washers connect the
Accessory Tray to the Accessory Tray Braces (7) . Start with one tripod leg and attach wingnuts.
Wingnuts should be positioned beneath the accessory tray. Do not tighten wingnuts until all
Accessory Tray Braces are attached as some adjustments may be required.
5. Attach Eyepiece Accessories
Attach accessories as suggested in Intended Use Diagram. For example insert penta mirror
assembly into focusing tube, then insert desired eyepiece into penta mirror assembly.
6. Remove Lens Cover from 60mm Objective Lens
Your Bushnell Voyager Telescope is now ready to be used. To obtain the fullest
enjoyment from your telescope, please refer to the additional information below.
HOW TO USE YOUR NEW TELESCOPE
Using the Penta Mirror Assembly:
1.
A Basic Description: Bushnell is proud to present the
Exclusive Penta Mirror Technology. This Penta Mirror
Assembly provides the benefit of a convenient 90 degree
viewing angle commonly associated with diagonal
mirrors. However, the Penta Mirror provides something
that diagonal mirrors cannot provide--right to left correct
views of the any object viewed through the telescope.
Unlike traditional diagonal mirrors that provide backward
images of objects seen on land and in the night sky, the
Penta Mirror allows correct images to be viewed. The
groundbreaking benefit of this technology is that when
viewing and locating objects through the telescope, when
you want to move to the left, you move it to the left
intuitively instead of fumbling around the sky becoming
increasingly frustrated that you can’t move the telescope
the way your intuition tells you that you need to move it.
Objects on land at great distances can be seen naturally (and readable) as if you were many times
closer to the object. Objects in the sky appear as they appear in most star charts. For the first time
ever, you will be able to see what you would expect resulting in excellent viewing satisfaction. In
addition, the penta mirror has a special insert that is easily removed by backing out the eyepiece set
screw and removing the insert to yield a 1.25” optical format receiver.
2. How-To-Use: Just like any
traditional diagonal mirror, place the
eyepieces directly into the rear of the
Penta Mirror Assembly then place the
Penta Mirror directly into the back of
the telescope focusing tube, erecting
lens or Barlow lens (See Intended
Configuration Diagram).
Using the ZOOM Eyepiece Assembly:
Fully Correct Image Reversed Image
Upside-Down Image Upside-Down & Reversed Image
Insert
Penta Mirror Zoom Eyepiece
Power Change Ring