Philips AZ1008 - Manual (Page 8)

General information on
recording
• Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
• This deck is not suited for recording on
CHROME (IEC II ) or METAL (IEC IV) type
cassettes. For recording, use only NORMAL
type cassettes (IEC type I) on which the
tabs have not been broken.
• The best recording level is set automatically.
Altering the VOLUME and DBB controls
will not affect the recording in progress.
• At the very beginning and end of the tape,
no recording will take place during the
7 seconds when the leader tape passes the
recorder heads.
• To protect a tape from accidental erasure,
have the tape in front of you and break out
the left tab. Recording on this side is no
longer possible.To record over this side
again, cover the tabs with a piece of
adhesive tape.
Synchro Start CD recording
1 Select CD source.
2 Insert a CD and if desired, program track
numbers.
3 Press STOP•OPEN 9/ to open the
cassette door. Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
• Playing of the CD program starts
automatically from the beginning of the
program. It is not necessary to start the
CD player separately.
6 For brief interruptions press PAUSE ;.To
resume recording, press PAUSE ; again.
To stop recording
7 To stop recording, press STOP•OPEN 9/.
➜ The CD player goes to pause mode.
Press PLAY•PAUSE 2; to resume CD
playback, or press STOP 9 to stop CD
play.
Selecting and recording a particular
passage
• During CD playback, press and hold down
the SEARCH buttons ∞ or § on the set
to find your passage.
• Press PLAY•PAUSE 2; to put the CD
player on pause at the selected passage.
➜ Recording will begin from this exact
point in the track when you press
RECORD 0.
Note: If you press RECORD 0 during
playback, recording starts automatically from
the beginning of the current track.
Recording from the Radio
1 Adjust the source selector to AM or FM to
select your desired waveband.
2 Tune to the desired radio station (see
Radio reception).
3 Press STOP•OPEN 9/ to open the
cassette door. Insert a blank tape.
4 Close the cassette door.
5 Press RECORD 0 to start recording.
6 For brief interruptions, press PAUSE ;.To
resume recording, press PAUSE ; again.
7 To stop recording,
press STOP•OPEN 9/ .
Recording
13
English
REPEAT
PROGRA M
B AT T.LOW
TAP OFF
MW FM CD
LIFT T O O PE N
AZ100 8
CD RA DIO C ASSETT E RECOR DER
CD S YNCH R O STAR T RECORDING
SE ARCH
ST O P
D Y N AM IC BAS S BOOS T
P L A Y / P A U S E
DBB
PROGRAM
RE PE AT
VOLU M E
N EP O O T T F I L
TUNING
CD TRA CK
PLAY
STOP • OPE N
PAUS E
SEAR CH SEAR CH
XP AZ 1008/17 19-10-2000 15:46 Pagina 13