Update from the configuration page – Philips DS3881W-37 User Manual

Page 24

Advertising
background image

24

4

Follow the on-screen instructions to

complete the firmware update.

Note

•

In case the firmware update fails, you can try the above

procedures again.

•

After successful firmware update, if there is any

problem with the Wi-Fi connection, press and hold

both the + and - buttons on DS3881W for more than

5 seconds at the same time to reset the device, and

then try to set up the Wi-Fi network for DS3881W

again (see ‘Connect to your home Wi-Fi network for

AirPlay’ on page 12).

Update from the

configuration page

Warning

•

Always connect your DS3881W to AC power for

firmware upgrade. Never power off your DS3881W

during firmware upgrade.

Note

•

To use an Internet browser other than Apple Safari

on your PC/Mac, remember to go to the Wi-Fi router

configuration page and write down the IP address of

your DS3881W. See the user manual of your Wi-Fi

router for how to find the IP addresses of devices

connected to the Wi-Fi router.

1

Power on DS3881W (see ‘Prepare’ on

page 11).

»

It takes about 35 seconds for the unit

to boot up. During boot-up, the WI-FI

SETUP indicator on the back of the

unit blinks green quickly.

»

After boot-up, you can hear a beep

and the WI-FI SETUP indicator

turns to green steadily. DS3881W is

connected to the last configured Wi-Fi

network automatically.

2

Make sure that DS3881W and your PC/

Mac are connected to the same Wi-Fi

router.

3

Open Apple Safari on your PC/Mac, then

select ‘Philips_Fidelio XXX’ from the

Bonjour pull-down list.

• Or open any other Internet browser

on your PC/Mac, then type in the IP

address of DS3881W (available on

the Wi-Fi router configuration page)

at the address bar.

»

The DS3881W configuration

web page is displayed.

EN

Advertising