Philips DVD590M-17 - Manual (Page 14)

14 Hookups (cont’d)
Connecting to a TV and a Digital Stereo
(Receiver has PCM, Dolby Digital TM , MPEG2, or Digital Theater System)
1 Connect the supplied yellow video cable to the Player’s
yellow VIDEO jack and to the corresponding VIDEO IN jack
on your TV.
2 Connect the Player’s COAXIAL Digital Audio Output jack
to the COAXIAL Digital Audio In jack on your Stereo. A
digital audio cable is not supplied.
3 Connect the supplied power cord to the MAINS ~
(AC Power) jack on the Player.
Connect the AC plug to a power outlet.
4 Press y y on the Player or its remote to turn on the Player.
Turn on the TV and set it to the correct Video In channel.
Such channels may be called AUX or AUXILIARY IN,
AUDIO/VIDEO or A/V IN, EXT1 or EXT2, etc.These
channels often are near channel zero (0). See your TV owner’s
manual for details. Or, change channels at the TV until you see the
Player’s blue background screen on the TV.
Turn on the Stereo and set it to the correct Digital Audio In
channel or sound source. Refer to the Stereo’s manual.
5 Set TV OUTPUT accordingly. Details are on page 33.
Set DIGITAL OUTPUT accordingly. Details are on page 36.
• You will have Multichannel
sound with this connection only
if your Stereo has a digital
multichannel decoder.
• Your Stereo must support
MPEG2, Dolby Digital TM or
Digital Theater System (DTS).
Check the Stereo’s manual.
• You may use S-Video or
Component Video connections
instead for higher picture
quality.These options must be
available on your TV. Details are
on pages 9-12.
Helpful Hints
DIGITAL
AUDIO OUTPUT
COAXIAL
VIDEO
S-VIDEO
Pr/Cr
Pb/Cb
Y
L R
MAINS
3
Back of TV
(example only)
VIDEO IN
VIDEO IN
COAXIAL DIGITAL
AUDIO IN
Stereo Receiver
(example only)
2
1
DVD590M_17x 6/11/2003 1:42 PM Page 14