Philips AZ1013 - Manual (Page 4)

Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Using AC Power
1 Check if the power voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the AC MAINS
inlet and the wall outlet.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the power
cord from the wall outlet.
• Unplug the power cord from the wall
outlet to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
Switching power on/off:
Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always adjust the source
selector to
TAPE/ OFF and check if the
cassette keys are released.
Standby power consumption...................3 W
General operation
1 To select your sound source adjust the
source selector to CD, AM, FM or
TAPE/ OFF .
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the source
selector to TAPE/ OFF position and check
the cassette keys are released.
Power Supply
9
English
AC M AINS ~
REPEAT
PROGRA M
B AT T.LOW
TAP OFF
MW FM CD
LIFT T O O PE N
AZ100 8
CD RA DIO C ASSETT E RECOR DER
CD S YNCH R O STAR T RECORDING
PLAY
STOP • OPE N
PAUS E
SEAR CH SEAR CH
SE ARCH
ST O P
D Y N AM IC BAS S BOOS T
P L A Y / P A U S E
DBB
PROGRAM
RE PE AT
VOLU M E
N EP O O T T F I L
TUNING
CD TRA CK
XP AZ 1008/17 13-10-2000 17:28 Pagina 9